 |
bearing for mining |
10,22,2016 |
|
bearing in mining |
10,22,2016 |
|
bearing of mining |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum pulley |
10,21,2016 |
|
bearing for mining pulley |
10,21,2016 |
|
| Current Location：Home
- News |
Self-aligning ball bearing disassemble method
|
| Time：2017.11.06 News Sources：Shandong Xinkaite bearing Co.,Ltd. Views：
|
Self-aligning ball bearing after the punch and die for sheet, strip, pipe and profile exerting force to produce plastic deformation, and then forming measures required for the workpiece, there are many ways to open the self-aligning ball bearing, self-aligning ball bearing today to introduce you to open the way:
First, push pressure method: press the bearing with press, the operation is stable and reliable, without damage to the machine and bearing shielding room. Press presses with manual push, mechanical or hydraulic presses.
Two, percussion method: knocking force is usually added to the bearing inner ring, shielding room knocking force should not be added to the rolling body of the bearing and the shelf, the use of this method should pay attention to the location of pad block should be appropriate, the focus should be correct.
Three, pull out method: select special puller, disassemble, just rotate the handle, the bearing will be gradually pulled out.
Four, heat removal method: used to disassemble tightly cooperative bearings. The first is heated to 100 DEG C at the mercy of the oil in the pot pouring on bearing to be demolished, the bearing ring by thermal expansion after, can pull out bearing out.
|
|
|
